Overview: A 5 pin, 20/32Amp, 3 Phase Leakage Adaptor for use with the following Seaward Appliance Testers:
- PAC3760 Plus. (Firmware Version 1.08 or Higher)
- PAC3760 Plus II
- PAC3760DL
- Primetest Elite (Protag Elite)
Application: The ProTag PAC-TPL 3 phase leakage adaptor is now available. This adaptor provides users of the Seaward systems (above) with the capability of powering up 10A, 16A, 20A and 32A appliances and carrying out a leakage current test. The test results are displayed on the Seaward unit, with both the actual reading and a Pass/Fail display.
Features:
Most three phase equipment incorporates electronic circuitry such as temperature controls, PLCs which control relays, or motors which require starter circuits such as contactors.
All of these types of controls, contactors and relays must be powered on to latch. Performing an insulation resistance test on such devices will only test up to the on/off switch and not show any faults inside the actual appliance.
The PAC-TPL three phase adaptors enable the applicable Seaward Appliance Tester to power up the 3-phase appliance under test. The results of the test are indicated on the Appliance Tester screen.
Specifications:
- PAC-TPL: 20A/32A, 500V, 50Hz
- Earth Continuity - see YOUR Seaward Test Instrument specification
- Test Voltage 3 phase supply voltage
- Test Duration continuous
- Display Range 0.15mA to 9.99mA
- Measurement Range 0.25mA to 9.99mA
- Accuracy +(5% + 2 digits)
- Frequency Response 50Hz
- Pass Value - 5mA
The PAC-TPL is ONLY suitable for use with the Seaward testers listed above.
The PAC3760 Plus must run the correct version of the firmware to enable use of this adaptor. (V1.08 or Higher)
